Edit
Structures
Layout
Fold rules
Brand
Inspect
Layout
Main view
3D box
Dieline
Whatever is not in the main view sits in the small view.
Click the small view, or the swap button, to change places. The two never show the same thing.
Show small view
Camera
Hero Pack shot ¾ right
Front Top
Perspective
Orthographic
Turntable
Trackball
Floor grid Left-drag orbits, middle-drag too. Right-drag or Shift-drag pans, wheel zooms.
Keys 1 / 3 / 7 give front, right and top, with Ctrl the opposite side; 5 toggles orthographic; Home frames the box.
The turn tool on the right spins the box itself while the floor stays put.
Fit main view
Studio layout
Every piece here can be dragged anywhere and hidden.
Hover a piece, then use its two small buttons — the left one drags, the right one hides.
Hidden pieces come back from the chips at the bottom left, or from this list.
The tabs on the left rail can be dragged up and down into any order.
Reset layout
Dieline
Rulers Grid Panel names and sizes Overlays
Measurements Contact shadow Render
Cast shadows Ambient occlusion Floor reflection Turntable Depth of field Snapshot
1× 2× 4×
The camera button saves the 3D view at this many times the screen size,
up to 4096 px, with every effect on.
The key light casts real shadows across the box, and the corners and creases
darken the way board does. Turn either off on a slow machine.
Drag to orbit, shift-drag to pan, wheel to zoom. The dieline pane keeps its own fit.
Fold rules
Fold rules · trainer
Every crease carries its own target angle and the step it
folds on. Drag a slider or type an angle — a minus angle folds the other way — and the
box folds that way at any size. Save the set as a packaging-fold-rules file, or load one
made for this structure elsewhere.
Show crease angles on the die
Save rules JSON
Load JSON
Reset
Fold steps
Nominal
As drawn
Assembly
Rig
Design
Base look
Plain board
Sample product
Orientation test
Diagonal stripes
Brand colour
Your designs
Upload more
Remove
Put it on
Outside
Inside
Every part
Whole blank
Drag a design onto the dieline and it lands right there on the blank,
ready to move and size with its handles. Every part gives each panel its own copy; whole blank stretches one design over the sheet.
Layers
Duplicate
Delete
Clear all
Adjust the selected layer
Adjust on the die
Fit
Fill
Stretch
Nudge
◀
▼
▲
▶
−
+
Offset X
Offset Y
Reset placement
Drag the layer on the die. A handle on its own changes only what it holds —
a corner takes width and height as you pull them, a side handle takes that one side.
Hold Shift on any handle and the whole design scales together, aspect locked.
The circle rotates. Arrow keys nudge a millimetre at a time, Shift ten, and
+ / − always resize the whole design. Offsets are real millimetres on
the blank, so what you line up here is what prints.
Orientation check
Set the base look to Orientation test and every panel gets an arrow,
its own name and an OUT or IN mark. Anything mirrored or upside down after folding shows up at once.
3D preview
00:00
100%
Editing outside
−
+
↺
↻
Fit
Fill
Stretch
Done
drag a handle to change just that side · hold Shift to scale the whole design ·
the circle rotates · arrows nudge 1 mm, Shift 10 mm ·
+ − resize the whole design · Alt turns snapping off